Should be the cartridge is out of ink , replace the cartridge to stylus color 600 , for example, as follows:

 

( 1 ) The printer is powered on.

( 2 ) Open the top cover of the printer.

( 3 ) Press the pause button , pause lights.

( 4 ) the primary key for ss t around to the left until the print head moves to the ink gold base installation location , pause light starts flashing.

( 5 ) Pull the cartridge lock lever cartridge from the base portion pops up.

( 6 ) out of the cartridge from the printer , to be properly addressed. Do not open the ink cartridges or try to re-use. Prior did not buy a new ink cartridge , do not put out the empty cartridge from the printer , if the printer is not installed in the printer ink cartridges and the print will be destroyed .

( 7 ) Open the new ink cartridge bag , remove the protective tape on the nozzle .

( 8 ) The ink cartridge nozzle down by one half the base , the arrow pointing to the upper rear of the printer ink cartridges . Color ink cartridge on the left base, black ink on the base of the right gold

( 9 ) Pull the cartridge lock lever and push the back of the printer until the locking cartridge.

( 10 ) aft key is pressed again to start the print head cleaning operation. ( Even without pressing the aft key when the print cartridge is installed after 30 seconds , the print head will automatically return to the initial position )

( 11 ) Close the printer cover, print head to print test .